The study of wood as a renewable material and organic material is what is known as wood science. Wood technology is now the way the tools are utilized in the processes of wood preservation. To be able to study wood it has to be compared to other products. The comparison made against other products will include the features of the material against those of wood, the value and the ease it can be worked on. The utilization of technology gives wood an upper hand in most of this comparison. Wood can be applied in very many applications, and this gives it an upper hand over other materials. Wood is renewable, and this makes it more precious. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.
The good appearance of your timber made structure cannot be guaranteed if protection of the timber is not done. The biggest threat to wood being moisture and insects has to be kept away from the wood. The water particles in the timber increase the rotting and the insects bore through the wood. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. The protection of from this chemical is based on copper. Although being a good method to use for wood protection it has presents some few challenges. It has been seen corroding most metals for example aluminum in less than six months of its application. The concentration of the chemical that will be used to treat a piece of wood will depend on the where it is going to be used and the molecular structure of the wood. Timber being used around a water body will be dipped in a more saturated fluid than that being used above ground.
The use of copper metal is another method of wood treatment that is fast being accepted. The use of this method is fast being accepted because it is not corroding the metal fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. This process is highly effective and the wood properties and heightened. The timber treated in this way is used in both outdoor and indoor frames that last very long.
Termites and fungal decay are just a few among the many problems wood treated from this method are protected against. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. Extensive research over a period of 10 years has proven the effectiveness of this science as one of the best wood preservation methods.